ER7210 660x330 ER7210 Electrical Resistance Probe with Large Flush Element

ER7210 Electrical Resistance Probe with Large Flush Element

Click to rate this post!
[Total: 3 Average: 5]
Model ER 7210 – Electrical Resistance Probe for the 2 inch Access System with Large Flush Element

Model ER7210 Flush-Mount Electrical Resistance Probe is a fixed-length probe for use with the 2″ access system in high pressure and high temperature applications. These probes are ideally suited for applications where the probe element needs to be flush with the wall of the pipe.

The probe assembly consists of an insertion rod with an element, a hermetically sealed connector, and a hollow plug nut, which are all welded in place. The hollow plug nut on the probe screws into the hollow plug of the access system. This allows the probe to be installed in the process, using a retriever tool and service valve, without process shutdown.

Insertion lengths range from 1.25″ to 36″ in 1/16″ increments. Several standard elements are available to meet your specific needs. Probe adaptors are available and must be ordered separately. (Refer to the Element and Alloy Selection Chart for more information)

Check Also

ER7200 2 310x165 ER7200 Electrical Resistance Probe for the 2 inch Access System with Flush Element

ER7200 Electrical Resistance Probe for the 2 inch Access System with Flush Element

Click to rate this post! [Total: 3 Average: 5]Model ER 7200 – Electrical Resistance Probe for …

Leave a Reply

Your email address will not be published. Required fields are marked *

This site is protected by petroparda.com